Plumbing
Home/Plumbing/Hydro-Jetting

Hydro-
Jetting.

When a snake just punches a hole through the clog, hydro-jetting scours the whole pipe wall — grease, sludge and tree roots gone.

Request Help ☏ (678) 758-3493

Overview

The difference between clearing and cleaning

Hydro-jetting clears a drain or sewer line with high-pressure water (up to ~4,000 PSI) that scours the full pipe wall — cutting through grease, sludge and tree roots and flushing them away. Unlike a cable "snake," which just punches a hole through the blockage, jetting restores close to the pipe’s full diameter, so the line stays clear far longer.

A drain snake punches a hole through a clog so water flows again — for a while. Hydro-jetting is different: high-pressure water scours the entire inside of the pipe, removing the grease, scale, sludge and tree-root intrusion that the clog was made of. The line comes back to nearly its original diameter, which is why jetted lines stay clear far longer than snaked ones.

What hydro-jetting clears

  • Grease and soap buildup in kitchen lines
  • Tree-root intrusion in sewer and drain lines
  • Sludge and scale in older pipes
  • Recurring clogs that keep coming back after snaking
  • Main sewer line blockages
  • Pre-inspection cleaning ahead of a camera run

When jetting is the right call

↻

The clog keeps returning

If you’re snaking the same drain every few months, the pipe wall is coated — jetting actually removes it.

🌳

Tree roots

Roots invade sewer lines through joints. Jetting cuts them out; a camera confirms the line after.

🍳

Kitchen grease lines

Years of grease narrow a pipe until it clogs constantly. High-pressure water strips it back to bare pipe.

⏳

Slow, whole-house drainage

When multiple drains slow together, the main line is coated or blocked — a job for jetting, not a plunger.

Why It Matters

Why jetting beats snaking for real clogs

01⌀

Cleans the whole pipe

Jetting restores near-full diameter instead of poking a hole — so flow comes back and stays back.

02🌳

Handles roots + grease

The two toughest blockages don’t stand up to 4,000 PSI. A snake barely dents them.

03📷

Camera-verified

We can scope the line before and after so you actually see the pipe is clean — not just flowing for now.

Risk

If You Wait

The clog you keep snaking is getting worse

Punching a hole through a clog treats the symptom. Here’s what the buildup does next.

The cycle

The clog keeps returning

Snaking opens a channel but leaves the grease and scale on the pipe walls. It closes back up in months.

SeverityRisk: Low
Narrowing

The pipe chokes down

Buildup hardens and roots follow the moisture in. The line runs at a fraction of its diameter.

SeverityRisk: High
The backup

The main line blocks

One flush too many and sewage backs up into the house — and a fully choked, root-bound line may need replacing.

SeverityRisk: Critical

The Cost

Clean the pipe, or replace it

The smart money

Jet it clean

$350–$800
  • Full pipe wall scoured
  • Roots + grease removed
  • Camera-verified after
The expensive way

Line replacement

$8,000–$15,000+
  • Excavated sewer line
  • Yard + driveway disruption
  • Sewage backup cleanup first
Waiting can cost up to 19× more
Jet it clean$350–$800
Line replacement$8,000–$15,000+

Typical North Georgia ranges — line length and access set the price. Camera inspection included where needed.

Plumbing

The Process

How a jetting job runs

01

Inspect

We often camera the line first to confirm jetting is right and rule out a broken pipe.

02

Access

We set up at a cleanout and feed the jetting hose to the blockage.

03

Jet

High-pressure water scours the pipe wall, cutting roots and grease and flushing them out.

04

Verify

A final camera pass confirms the line is genuinely clean and flowing full-bore.

Near You

Hydro-Jetting near you

Hydro-Jetting · WoodstockHydro-Jetting · Acworth All service areas →

FAQ

Hydro-Jetting questions

Straight answers on hydro-jetting in North Georgia. Can’t find yours? Ask a real human.

☏ (678) 758-3493
Is hydro-jetting better than snaking a drain?+

For recurring clogs, grease and tree roots — yes. A snake clears a path through the blockage; jetting removes the blockage and the buildup coating the pipe, restoring near-full diameter. That’s why jetted lines stay clear much longer.

Is hydro-jetting safe for my pipes?+

For pipes in sound condition, yes — we camera the line first to confirm it can take the pressure and to rule out a break. If a pipe is already cracked or collapsed, jetting isn’t the answer and we’ll tell you what is.

Clog that won’t quit?

Stop snaking the same drain. Jetting clears it for good — and we’ll prove it on camera.

☏ (678) 758-3493
Help

Request Help

You flush. We handle the rest. Deal?

Tell us what’s going on — we’ll get back to you within one business hour.

  • No-pressure estimates
  • Response within 1 business hour
  • Licensed, insured & local — one crew for plumbing and septic
Or call
(678) 758-3493
24/7 SERVICE • 60-MIN RESPONSE • ☏
By submitting you agree to our privacy policy. We never share your info.
☏ For Emergency Call NowAvailable 24/7